Kichler 15092 Manuale Utente Scaricare il pdf (Pagina 1)

INSTRUCTIONS PERTAINING TO A RISK OF FIRE,OR INJURY TO

PERSONS

IMPORTANT SAFETY INSTRUCTIONS

Lighted lamp is HOT!

WARNING — To reduce the risk of FIRE OR INJURY TO PERSONS.

1) Turn off / unplug and allow to cool before replacing lamp.

2) Lamp gets HOT quickly! Contact only switch / plug when turning on.

3) Do not touch hot lens or cowl.

4) Do not remain in light if skin feels warm. (Light is intense, it may cause

“sunburn”.)

5) Do not look directly at lighted lamp.

6) Keep lamp away from materials that may burn.

7) Useonlywithwattageandlampmarkedonxture.

8) Do not touch the inner glass envelope of the lamp at any time. Use a soft cloth.

Oil from skin may damage lamp.

9) Donotoperatethexturewithadamagedormissinglens.

SAFETY INSTRUCTIONS

READ THIS FIRST

KEEP THESE INSTRUCTIONS

This xture is intended for installation in accordance with the National

Electric Code (NEC) and Local code specications. Failure to adhere to

these codes and instructions may result in serious injury and/or property

damage and will void the warranty.

1) WARNING: Thisxtureisnottobeinstalledwithin10feet(3M)ofapool,

spa or fountain.

2) Thisxtureistobeusedonlywithapowerunit(transformer)ratedamaximum

 of300W(25AMPS)15volts.

3) AccordingtotherequirementsoftheNationalElectricCode(NEC),direct

burial rated wire is to be buried a minimum of 6” [152mm] beneath the

surface of the ground.

NOTE: If additional Direct Burial wire is needed, contact your local

Kichler

landscape distributor.

 •8GAwirecanbepurchasedinlengthof250’(76M),15503-BK.

 •10GAwirecanbepurchasedinlengthof250’(76M),15504-BK.

 •12GAwirecanbepurchasedinlengthsof100’(30M),15501-BK;250’

  (76M),15502-BK;500’(152M),15505-BK;and1000’(304M),15506-BK.

4) Fixtureshallnotuseatungstenhalogenlampunlessthextureismarked

for use with such lamps.

5) Wiringconnectionsmustbemadewithapproved/listedwireconnection

 device(s)suitablefortheapplication.Donotexceedmanufacturers’wiring

 combinationspecicationsforsizeandquantityofconductors.

CAUTION

WHEN INSTALLING KICHLER LANDSCAPE LIGHTING (LINE VOLTAGE OR LOW VOLTAGE),

CARE SHOULD BE TAKEN TO KEEP CLEAR OF POTENTIALLY COMBUSTIBLE MATERIALS.

WHEN MAINTAINING THE FIXTURES, BE SURE TO REMOVE LEAVES, PINE NEEDLES,

GRASS CLIPPINGS, MULCH, OR ANY DEBRIS THAT HAS ACCUMULATED ON THE LIGHT

BULB, LENS, OR BODY OF THE FIXTURE.

WELL / ACCENT LIGHT ASSEMBLY

FIXTURE IS SUITABLE FOR OUTDOOR USE ONLY

1) Well/accentlightcanbeinstalledtwodifferentways.

  A)Ifaccentlightistobeusedfordirectuplighting,dighole15”deep.

  B)Ifaccentlightistobeusedforwallwashing,dighole9-1/2”deep.

These dimension will make hole deep enough to accommodate sleeve

plus 6” of pea gravel to insure proper drainage.

2) Fill bottom of hole with 6” of pea gravel.

3) Setsleeveinhole.

  A)Directuplighting:Angledenddown.(Notillustrated)

  B)Wallwashing:Angledendup.(Illustrated)

4) Using denatured alcohol clean both sides of yoke where rubber pads are

to be taped. Denatured alcohol will remove any oil, dirt or residue that may

keep rubber pads from sticking.

5) Remove paper backing from rubber pads and stick to yoke.

6) SlipO-ringoveraccentbodyandintoO-ringgrooveclosesttocenterof

accent body.

7) SlipsecondO-ringintoO-ringgroovefarthestfromcenterofaccentbody.

8) InstallMR16lamp(notsupplied)intosocketinsideaccentbody.

NOTE: Use caution when assembling. Hold lamp by outer housing.

 DONOTtouchglassenvelopeinside.Ifthishappens,cleanbulbwith

denatured alcohol and a lint free cloth.

DateIssued:12/2/11 IS-15092-US

For warranty information please visit: http://www.landscapelighting.com/portal/warranty_page

Para informacion de la garantia por favor visite: www.landscapelighting.com/portal/warranty_page

QUIC DISC

™

WIRING INSTRUCTIONS

Turn off power.

Thefulllengthofthe18GAxturewiremaybeusedtoconnectwiththe10GAor12GAcableprovidedthefollowingconditionsaremet:

•Wiringistobeprotectedbyroutingclosetothextureoraccessoryorsecuredtoabuildingstructuresuchashouseordeck.

• 18GAxturewiringistobecutoffsothatitisattachedtotheconnectorwithin6inchesofthextureorbuildingstructure.

• Ifitisnecessarytomaketheconnectionsunderground,thennomorethan6inchesofthe18GAxturewireistobeburied.

The Quic Disc

™

connector is designed to install onextureandaccommodatesone18GAxturewireandone10GAorone12GAsupplywire.

Placethe10gaugesupplywireacrosstheareamarked10GAonQuicDisc

™

orplacethe12gaugesupplywireacrosstheareamarked12GA

on Quic Disc

™

Placethe18gaugexturewireacrosstheareamarked18GAontheQuicDisc

™

.Afterthewiresareinplace,connectathetopoftheQuic

Disc

™

tothebasewithsuppliedscrew,makingsurethatthewiresremainatinthebottomportionoftheQuicDisc

™

, and the screw is tightened

all the way down.

Thecoppercontactswillautomaticallypiercethewires’insulation.Excess18GAxturewirethatsticksouttheendoftheQuicDisc

™

is to be cut off.

Makenootherwiringconnectionstothe18GAxturewire.

9) Assemblecowlwithlenstoaccentbody.Secureinplaceusingeitherthe

provided thumbscrew or the vandal resistant screw. NOTE: Vandal

 resistantscrewrequiresa3/32hexkey(NotProvided)forinstallationor

removal.

10)Unscrewphillipsheadscrewsinyokeenoughtoslipcowlbetweenrubber

pads.

11) Tighten phillips head screws until cowl is held securely in place.

12)Guidewirefromaccentbodyunderbottomofsleeveandbackupbetween

sleeve and soil.

13)Slipyokehookoveredgeofsleevetosupportaccentlight.

14) Fill gaps surrounding outside of sleeve with soil.

15)MakewireconnectionsusingsuppliedQuicDisc

™

following instructions

below, or using other approved wiring connection method (not supplied.)

HOOK

GANCHO

YOKE

HORQUILLA

RUBBERPAD

ALMOHADILLADEGOMA

LENS

LENTE

COWL

CAPUCHA

THUMBSCREW

TORNILLODEAPRIETE

MANUAL

O-RING

ANILLOENO

O-RINGGROOVE

RANURADEANILLOENO

ACCENTBODY

CUERPODEACENTO

SLEEVE

CAMISA

1 2

Sommario

Pagina 1 - Lighted lamp is HOT!

INSTRUCTIONS PERTAINING TO A RISK OF FIRE,OR INJURY TO PERSONSIMPORTANT SAFETY INSTRUCTIONSLighted lamp is HOT!WARNING — To reduce the risk of FIRE OR

Pagina 2 - LAS PERSONAS

INSTRUCCIONES PERTINENTES A UN RIESGO DE ICENDIO O LESION A LAS PERSONASINSTRUCCIONES IMPORTANTES DE SEGURIDAD¡La lámpara encendida es CALIENTE!ADVERT